The button type magnetic ring is also called a snap-type magnetic ring, a clip-on magnetic ring, a clip-on magnetic ring, or an assembled magnetic ring, an assembled magnetic ring, etc., but the same product is used. One of the anti-interference magnetic rings.

Development of clip-on magnetic rings :

At present, the domestic button-type magnetic ring specifications are basically imitation of some foreign brands, independent mold production and mass production, but the corresponding English words on the outer shell. The main point is that the domestic products are cheap, precisely because many users have already replaced the original products.

Clip-on magnetic ring specifications:

The current specifications are basically complete, up to more than 10 specifications, can be applied to different wiring harnesses, the smallest for 1M wire diameter, the largest can reach 19MM cable. Except for some special specifications, there is currently no production in China, perhaps because it is used less domestically.

The choice of clip-on magnetic ring :

If you are using this product for the first time, what should you start with? The following is a brief introduction.

First, determine the wire diameter. The wire diameter mentioned here is the diameter of the wire harness you need to install.

Second, when installing, do you need to directly buckle or need to wind around 1-2 laps. Here, emphasize that the effect of direct buckle is not good after winding.

Third, select the appropriate button magnetic ring for different wire diameters (as shown in the figure). If your wire diameter is only 5MM wire diameter and you want to directly buckle it, it is recommended to use SCRC70B if you want to wrap around. It is recommended that you use SCNF100. Here is a brief introduction. This option requires a detailed understanding of some other problems to be recommended. If you need to choose a more suitable specification, you can consult the customer service.

Installation is relatively simple and convenient, open directly buckle or wrap a few turns and then buckle. Be sure to choose the size that suits you. You can't choose a small size. If you can't buckle it, you will hurt the line. If you choose too large, it will not work well.