Nickel-zinc Dongguan introduction to NI-Zn magnetic ring magnetic ring:

Zinc-nickel magnetic ring main ingredients: ferric oxide (Fe₂o₃), zinc oxide (ZnO), nickel oxide (NiO), copper oxide (CuO), manganese carbonate (MnCO₃) maximum levels respectively, 10%, 60%, 15%, 5%. After dosing, moulding, sintering furnace kiln formed.

1. zinc-nickel magnetic ring

Signal frequency, the higher, the more radiation, and General signal cable is not shielded layer of these signal lines becomes a good antenna, receiving various messy high frequency signals in the environment, and these signals are superimposed on the original transmitted signal, or even alter the transmission signal. In the presence of zinc-nickel magnetic ring to allow useful signals well through, and could well inhibit high-frequency interference signals through, and low prices.

2. application of zinc-nickel magnetic ring

Zinc-nickel magnetic products used in computer monitors LCD TVs, electric cable, flat ribbon cable line, interference filter line, communications equipment, electrical cable, power cord, USB cable series of anti-jamming performance.

A. Good electrical and mechanical design and application of the principles of

First of all, excellent EMC design is the basis of good electrical and mechanical application of design principles. These include reliability, such as design specifications meet the acceptable tolerances, good Assembly method and test technology under development. In General, the driving device of today's electronic devices to be mounted on the PCB. These devices have the potential sources of interference and electromagnetic energy-sensitive components and circuits. Therefore, anti-jamming magnetic ring is the next most important problems in EMC design. Location of active elements, printed line alignment, impedance matching, grounding design and filtering circuits shall be taken into account in the EMC design. Some PCB components and shielding is needed.

B. Internal cable connections

Once again, internal cable is generally used to connect PCB or other internal components. Therefore, including wiring and internal EMC shielding design for any given device is very important for the overall EMC. Within the EMC design of PCB and cable design is complete, should pay particular attention to the case of shield design and all gaps, perforation and processing method of cable through hole.

C. Power supply and cable filter

Finally, you should also focus on power and other cables for input and output filtering.

3. the method of anti-jamming magnetic ring:

Zinc-nickel magnetic rings are often used to inhibit power cord, signal interference on the line, but also has the ability to absorb electrostatic pulses.

(1) directly over one or a bunch of power supplies, signal line, interference in order to increase the absorption of energy, can be repeated around a few more laps;

(2) interference with installation clip magnetic ring magnetic ring, interference suppression applies to compensation;

(3) can be easily caught in the power cable, signal cable;

(4) a flexible, reusable installation;

(5) with bayonet fixed, does not affect the overall image of the device.

4. test methods for zinc-nickel magnetic ring

Zinc-nickel magnetic ring size 0.02mm with precision Vernier caliper for testing in normal lighting.

Zinc-nickel magnetic ring appearance in normal lighting conditions by Visual inspection.

Nickel-zinc integrated factor of the magnetic ring with "CF-3A-magnetic separation apparatus" measurement, excitation current is set to 2.5A, the frequency 40KHz.

Zinc-nickel magnetic core inductance with "YD2810D-LCR digital electric bridge" at 1KHz frequencies were measured.

NI-Zn induced electromotive force of magnetic ring "UI100 high frequency power source" and "UI9720 magnetic motion analysis system" under the stated conditions, were measured.

Nickel-zinc zinc Dongguan nickel magnetic ring magnetic ring